WD40 Contact Cleaner 360

360 ML

Fast-Drying Contact Cleaner

Cleans away oil, dirt, flux residue and condensation from sensitive electronics and electrical equipment, by rapidly penetrating hard-to-reach areas and dries quickly without leaving any residue

Features & Benefits:

  • Dielectric strength up to 35,000 Volts per 0.1 inch
  • Fast-acting, non-conductive cleaner
  • Penetrates quickly, fast drying and leaves no residue
  • ROHS Compliance

Applications:

  • Circuit Boards
  • Controls
  • Electrical Assemblies
  • Printers and Copiers
  • Switches
  • Tape Heads and Precision Instruments

Product Features

WD-40 Specialist Contact Cleaner is a solution that cleans oil, dirt, flux residue and condensation from sensitive electronics and electrical equipment. It rapidly penetrates hard- to- reach areas and dries quickly without leaving any residue.

• Isolate all electricity and allow hot surfaces to cool.


• Make sure all stored power is drained from the system.


• Shake can well before use.


• Hold can 15cm to 20cm away from the surface and spray directly onto the electronic device or circuit board to eliminate and remove contaminants that may cause loss of electrical contact.


• Tilt surface while cleaning and allow any excess cleaner to run off.


• Allow product to dry completely and thoroughly vent the system before restoring power.